Machsupport Forum

Mach Discussion => Mach Screens => Works in progress => Topic started by: TXJM on October 16, 2018, 11:26:17 AM

Title: Reversion to Standard Mach3 screen
Post by: TXJM on October 16, 2018, 11:26:17 AM

I purchased the X/Z axis, controller and pc(with installed Mach) from EZ Router.  I am using this as the basis of a piece of equipment that runs a repetitive job.  I don't have much use for the buttons on the custom router screen that came with the controller.  How hard is it to convert the main screen to be the default Mach3 screen.  They have added functionality to multiple buttons to ensure the machine is homed well every time.  I would like to utilize the standard screen.  Can I do this without reinstalling Mach3?
Chip Miles

Title: Re: Reversion to Standard Mach3 screen
Post by: ger21 on October 16, 2018, 12:01:25 PM

Quote

How hard is it to convert the main screen to be the default Mach3 screen.

From the View menu, select "Load Screens".
Select 1024.set in the Mach3 folder.
Done.

Title: Re: Reversion to Standard Mach3 screen
Post by: TXJM on October 16, 2018, 12:26:35 PM

Awesome.  I was beginning to dig through support documentation.  This short cuts that. 
Thank you very much
Chip Miles