Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Cole2534 on September 20, 2018, 04:20:15 PM

Title: Mach3 Torch Height Control with Hypertherm 45xp
Post by: Cole2534 on September 20, 2018, 04:20:15 PM

Hello all.

I've recently updated my plasma power source to a Hypertherm Powermax45xp.  Is there a tutorial on how to integrate this machine into Mach3 without an auxilliary THC?  With it's on-board voltage divider and other I/O I figured it would be a simple task but I cannot find much about it. 

Ideally I'd use a probe function to touch the plate, reset Z, pierce and then use torch voltage to control the height.

Is this possible?

Thanks, Cole