Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: tcmartin61 on August 11, 2018, 01:51:15 PM
-
After 4 years my computer started going south but was able to get all my data before I said good bye.
Now with a new one in hand ( wind 7 32 bit ) I have loaded my data back into place including my old
mach 3 settings. The only setting I had to change was the Parallel port address.
Now when I start Mach up my spindle speed (depending on the pulley) will only go between 5000-10000 rpm. More the likely something
else changed and just not catching it.
The machine is china built with with a converter to Phase 1. The Spindle is 3.2 Kw , 220v 10a 240000rpm 400Hz.
I have read way to much on this today with no luck, could someone ease my brain on this one.