Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Johnansaro on April 26, 2018, 02:08:49 PM

Title: Hotkeys are not working
Post by: Johnansaro on April 26, 2018, 02:08:49 PM

Hi there

I am trying to change my axis, through hotkeys but nothing is happening.
what i want to do is change my left and right to be my Y axis, and up and down arrow to be my X axis, Is this possible?
What I did was going Config>System Hotkeys>and I press X++>"SetHotKeys"> Then I press the Up arrow, but nothing happens.
What is it that I need to do?

regards
jhonansaro

Title: Re: Hotkeys are not working
Post by: Tweakie.CNC on April 27, 2018, 01:39:57 AM

Quote

What I did was going Config>System Hotkeys>and I press X++>"SetHotKeys"> Then I press the Up arrow, but nothing happens.

You should notice the Scan Code for X++ has changed to 38.

If this does not happen then check your keyboard operation is OK.
If keyboard is OK then I suggest you reload Mach3 from scratch.

Tweakie.

Title: Re: Hotkeys are not working
Post by: Johnansaro on April 27, 2018, 12:18:52 PM

Hi Tweakie

thanks for the reply. Strangely this time as I tried to change my Hotkeys, The X++ value has indeed changed to 38, but before it never changed.
My lap top is not connected to my Machine controller at the moment, I will try it in actual world tomorrow I will let you know.

reagards
jhonansaro