Machsupport Forum

G-Code, CAD, and CAM => LazyCam (Beta) => Topic started by: Chip on July 12, 2007, 10:45:32 PM

Title: LazyCam 2.02
Post by: Chip on July 12, 2007, 10:45:32 PM: Hi, Art & Brian

Very Very Nice, My small airfoil/spilins now load's with .001, Conn.

line Toll. and Offset Properly, Nice and smooth.

Inside/Outside working Correct hear on this one now.

There are 4 that Did Offset before, But not now, See Below, Dxf Also.

The airfoils/splines were the bigest problem for Me.

Rapids for Arc's Don't change end's when moved.

Rapids for Lines Do change now, Maybe thy did before, Not sure.

Art, The "UN-Group" I Was talking about (Previous Yahoo Post), I think,

Would allow some of us to generate Lathe G-code.

Not trying to Un-group a Square/Closed Chain, Just a Line-Arc-Line Caine.

If you'd PM your PH #, I could probable better explain my thought's on this.

Any Way, Were Putting Together a Collection to Re-Attachl all that Pulled Out Hare, Save It,(;-}}.

Thank So-Much, Chip
Title: Re: LazyCam 2.02
Post by: Chip on July 13, 2007, 02:34:17 AM: Hi, Art & Brian

The view Outside Offset, Wouldn't offset the top shape by it's self or with all selected.

Circle top offsets wrong.

Square doesn't offset top right corner

Inside Offset View, Circle off, Wouldn't offset the top shape by it's self or with all selected, Square Looks OK

Another example, Chip
Title: Re: LazyCam 2.02
Post by: Chip on July 13, 2007, 03:11:56 AM: Hi, Art & Brian

Just some more.

Thanks, Chip
Title: Re: LazyCam 2.02
Post by: ART on July 13, 2007, 01:52:30 PM: Chip:

I had a tolerance set too severe in some offsetting, so redownload the updater.. may or may not fix your current trouble..

Art
Title: Re: LazyCam 2.02
Post by: Chip on July 26, 2007, 09:06:37 AM: Hi, Art & Brian

Still having problems with Arc's, End points not being respected by LCam.

Hears the Dxf and LCam files.

Using .000001 Con. load toll., seems best, In-Out's backwards hear.

Square outside offset above doesn't close upper right corner.

Thanks, Chip