Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: CNCharly on December 14, 2017, 04:45:32 PM

Title: mcJogVelocityStart / MC_JOG_POS / MC_JOG_NEG does not work as expected
Post by: CNCharly on December 14, 2017, 04:45:32 PM

I try to setup my jogging device and want to use mcJogVelocityStart to move either in the positive or negative direction. I see, that MC_JOG_NEG does not work, I have to use MC_JOG_POS a seconds time instead. Also the Mach4 Core Api documentation for function mcJogVelocityStart uses two times MC_JOG_POS to switch from positive to negative direction. MC_JOG_STOP does not work in my case also, it continues to drive in one direction.
Is there a correct or better way to guide the machine into the right directions during jogging?
Thanks for any ideas.
Karl

Title: Re: mcJogVelocityStart / MC_JOG_POS / MC_JOG_NEG does not work as expected
Post by: CNCharly on December 15, 2017, 05:38:28 AM

Could solve it by myself. It was a mismatch of parameters, sorry.
Karl