Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: stirling on June 29, 2007, 03:36:14 PM

Title: limit override
Post by: stirling on June 29, 2007, 03:36:14 PM

I think I probably wandered off topic when I put this on the end of another post so here it is anew.

I upgraded from R1.84.002 to R2.00.065 and noticed that limit override (both manual and auto) doesn't appear to work. There's just no way to get off a limit (other than disabling them in ports n pins).

Has anyone else come accross this or have I set something up wrongly?

I've switched back to  R1.84.002 for the moment and everything is fine.

Title: Re: limit override
Post by: Hood on June 29, 2007, 03:51:13 PM

Not 100% sure but I think I am using R2.00.65 on my mill and the Auto Limit Override works fine. If I remember I will check it out tomorrow when I go to the workshop.
Hood