Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: parth1799 on October 05, 2017, 04:29:06 AM

Title: Modbus input output support works with parallel port?
Post by: parth1799 on October 05, 2017, 04:29:06 AM

Dear experts,

i have question regrading parallel port. can any one tell me, when i activate "modbus input output support" in "configuration port and pin" my parallel port works properly.

means i want to give input signal to mach3 using "modbus input output support" and i want to give output to parallel port for controlling breakout board. both are working together without problem?Huh

i hope you can understand my question.

pls help me to figure out this problem.

thanks & regards
Parth Jetani

Title: Re: Modbus input output support works with parallel port?
Post by: joeaverage on October 05, 2017, 07:33:37 AM

Hi,
yes the parallel port continues operation along with Modbus at the same time.

Craig

Title: Re: Modbus input output support works with parallel port?
Post by: parth1799 on October 06, 2017, 12:34:09 AM

ok thanks joeaverage

i want to control feedrate using arduino. so using this feedrate i want to control my stepper by breakout board right.

so it is possible ..... now i will plan to buy arduino and breakout board for my WEDM project. thnaks....