Machsupport Forum
Third party software and hardware support forums. => Third party software and hardware support forums. => Topic started by: TPS on July 06, 2017, 11:19:32 AM
-
on my TongIL retrofit Project, i am at the spindle now.
the spindle has a pulse code A20B-9000-0380.
on the web i found two different types.
i have the the one with the following signals:
0V -> GND
5V -> Power supply
VA
VA/ the Sinus wave
VB
VB/ the Cosinus wave
so far so clear and i can measure the signals with the scope
then we have a
VZ witch should be the Zero pulse
the is no VZ/.
i have measured VZ to GND allways 2,5V
i have measured VZ to 5v allways -2,5V
i was never able to see a pulse on the scope.
maybe one of you has got any further ideas.
Regards Thomas