Machsupport Forum

Third party software and hardware support forums. => HiCON Motion Controller => Topic started by: shad71 on April 09, 2017, 05:18:26 AM

Title: Support synchronous with motion commands M10Px/M11Px for Mach3
Post by: shad71 on April 09, 2017, 05:18:26 AM

Hello!
Does the HiCON INTEGRA controller support synchronous with motion commands M10P(output number)/M11P(output number) for Mach3 and M62 P(output number)/M63 P(output number) for Mach4?
Thank you!

Title: Re: Support synchronous with motion commands M10Px/M11Px for Mach3
Post by: Vital System Support on April 09, 2017, 12:53:15 PM

hi shad71,

HiCON Integra supports Mach4 sync outputs M62/M63.  Sorry no support for Mach3 M10/M11.

regards

Rufi
VitalSys

Title: Re: Support synchronous with motion commands M10Px/M11Px for Mach3
Post by: shad71 on April 09, 2017, 03:06:13 PM

Thank you Rufi.