Machsupport Forum
Third party software and hardware support forums. => HiCON Motion Controller => Topic started by: Cbyrdtopper on April 04, 2017, 08:23:16 AM
-
Okay, I had written a probe macro that checks for a broken tool. Here are the basics of the macro.
Move down above the probe
Probe at 50 IPM Here is that Probing Line of code. "G31 G91 Z -2.00 F50"
If probe strike, then "Tool OK"
else "Tool Broken"
Move to safe Z
End
It was working great last week and yesterday it stop after the probe signal was activated. The macro was still running, doing nothing. Now, I slowed the Feed down to 25 and it seemed to take care of the problem.
Any ideas what happened?