Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Len-Tikular on March 14, 2017, 02:54:02 PM

Title: G53 Incremental Block message
Post by: Len-Tikular on March 14, 2017, 02:54:02 PM

When attempting to home all with Machturn I get the following message.
Cannot use G53 Incremental Block GoG53Z0.0000

Set home Z and set home X both work fine.

I am using Machturn 3 with ESS Smoothstepper and CM106

George

Title: Re: G53 Incremental Block message
Post by: Len-Tikular on March 15, 2017, 01:15:55 PM

Quote from: Len-Tikular on March 14, 2017, 02:54:02 PM

When attempting to home all with Machturn I get the following message.
Cannot use G53 Incremental Block GoG53Z0.0000

Set home Z and set home X both work fine.

I am using Machturn 3 with ESS Smoothstepper and CM106

George

Change mode from Inc to Abs and Home All works fine.

George