Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: kutton on March 08, 2017, 08:00:19 PM

Title: Mac3 software
Post by: kutton on March 08, 2017, 08:00:19 PM

When I go to motor tuning and put velocity  data in.  When I tab to acceleration the velocity goes to zero.

Any suggestions?

Title: Re: Mac3 software
Post by: kolias on March 08, 2017, 08:08:51 PM

On which axis this happens? what are the other values on the screen?

Title: Re: Mac3 software
Post by: kutton on March 08, 2017, 08:21:50 PM

All axes.   Currently working on x axes.

Title: Re: Mac3 software
Post by: kutton on March 08, 2017, 08:23:28 PM

200 in steps acceleration 10

Title: Re: Mac3 software
Post by: Davek0974 on March 09, 2017, 06:08:24 AM

Did you remember to press "Save Axis Settings" before changing the tab/screen??

Title: Re: Mac3 software
Post by: kutton on March 09, 2017, 07:47:51 AM

Never get that far

Title: Re: Mac3 software
Post by: Tweakie.CNC on March 09, 2017, 08:11:32 AM

Sounds like a bad install.

Try re-installing Mach3 (version R3.043.062 would be best) and see if that cures the problem.

Tweakie.