Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: da40flyer on March 01, 2017, 03:29:55 PM

Title: Touch Button - Outside Diameter
Post by: da40flyer on March 01, 2017, 03:29:55 PM

Looking at the measurements that can be taken under the "Touch" button, I see one for finding the center of a hole. 
Is there one for finding the center of a solid rod (measuring via the outside diameter)?

Title: Re: Touch Button - Outside Diameter
Post by: Zeeflyboy on March 03, 2017, 05:36:19 PM

unfortunately there doesn't yet appear to be a "boss" type function in the touch UI.

It is there under probing though, so hopefully they might add it to the touch UI too.

Title: Re: Touch Button - Outside Diameter
Post by: da40flyer on March 08, 2017, 09:41:03 AM

How does the Probing tab function differ from the Touch GUI?