Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: paragon on December 11, 2016, 02:59:02 PM

Title: power outage problem
Post by: paragon on December 11, 2016, 02:59:02 PM

Hi...after power outage ,one motor is not working...is therea reset for drivers..bob?....thanks

Title: Re: power outage problem
Post by: Davek0974 on December 11, 2016, 03:06:46 PM

not usually, just full power-down and restart, check your fuses/mcb's etc.

Title: Re: power outage problem
Post by: paragon on December 11, 2016, 03:10:46 PM

Thanks,  do the drivers usually have fuses?....what is mcb?...pardon my ignorance

Title: Re: power outage problem
Post by: Davek0974 on December 11, 2016, 04:38:37 PM

No idea what system you have but there usually is a fuse or Magnetic Circuit Breaker (like a fuse but one that can be reset over and over, looks like a switch) in the supply somewhere. If there is none then it looks likely a drive has blown, the fact that other axes are working looks this way.

Title: Re: power outage problem
Post by: paragon on December 11, 2016, 05:05:53 PM

thanks for your help...i'll look for fuse or mcb tomorrow...