Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: NigelW on October 04, 2016, 01:19:57 PM

Title: Reinstalling Mach3
Post by: NigelW on October 04, 2016, 01:19:57 PM

After encountering some problems with Mach3 (I am a complete beginner), I decided to uninstall and reinstall Mach3 to see if that helped. I've clearly done something wrong because the reinstall hangs after a few seconds with the message 'A sharing violation has occurred while accessing an unnamed file'. I can only assume that I have uninstalled incorrectly. Can anyone help? Nigel

Title: Re: Reinstalling Mach3
Post by: RICH on October 04, 2016, 01:49:28 PM

Curious as why you just ignored replies in your other threads and decided to reinstall MACH?

RICH

Title: Re: Reinstalling Mach3
Post by: NigelW on October 04, 2016, 02:06:59 PM

Good question! Just impulsive I guess and clearly not very bright, but it seemed a simple and obvious thing to do (the old turn it off and on again trick). I wasn't anticipating it being so complicated. But we are where we are and I'm afraid I'm a bit stuck.

Title: Re: Reinstalling Mach3
Post by: RICH on October 04, 2016, 02:12:33 PM

What Windows version do you have?

RICH

Title: Re: Reinstalling Mach3
Post by: NigelW on October 05, 2016, 03:28:17 AM

Windows XP