Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Bill I on July 07, 2016, 10:46:06 PM

Title: Z-Zero problem
Post by: Bill I on July 07, 2016, 10:46:06 PM

Using MACH 3 version R3.043.062 USB Smooth Stepper, PMDX 126 BOB and 134 Mother Board.  Since changing over to the smooth stepper I must load a cut file into Mach before I can Z-Zero the spindle or use any of the icons on the 2010 Screen Set.   Is there something I need to change in MACH or is this a Smooth Stepper issue?

Thanks
Bill I