Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: mmihld on May 23, 2007, 12:33:34 AM

Title: step rate on maxnc ol
Post by: mmihld on May 23, 2007, 12:33:34 AM

I finally got the mach3 running.  thanks for the advise.  it now seems to drive the motors, however, the step rate is too fast.  i did a search on this forum for this problem and i think in need a xlm file for the maxnc 10 ol.   i have searched for this, but cant find it!  anyone have the xlm file for the maxnc 10 ol??

Title: Re: step rate on maxnc ol
Post by: blackrat6355 on May 23, 2007, 06:17:16 PM

I don't have the xml file for the maxnc ol. I have a maxnc cl2. Try setting the steps to 4000. This worked for my mill. If you hit the tab key you can also set your jog speed.

Jeff

Title: Re: step rate on maxnc ol
Post by: Brian Barker on May 27, 2007, 01:36:14 PM

Please change your Motor tuning settings under Config / motor tuning

Thanks
Brian

Title: Re: step rate on maxnc ol
Post by: mmihld on May 27, 2007, 01:58:15 PM

what should the settings be?

Title: Re: step rate on maxnc ol
Post by: Brian Barker on May 27, 2007, 02:04:58 PM

Set them to what you feel looks good :)
It is not the same for all machines :(