Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Holzwurm56 on June 13, 2016, 06:47:36 AM

Title: Problem with Spindle Speed Control
Post by: Holzwurm56 on June 13, 2016, 06:47:36 AM

Hello,
I use Mach3Turn for Lathe with control about 2 printerports. In the diagnosticsmode i can see the indexsignal working, but in the manual or automatic mode the spindlespeed display shows allways zero. I have test this with a low and a high spindlespeed.
Have someone a idea what i made wrong?

Many thanks for your answer

Hans

Title: Re: Problem with Spindle Speed Control
Post by: rcaffin on June 22, 2016, 01:00:55 AM

Check pin assignments. You probably have the index signal wrongly assigned. It should work.

Cheers
Roger