Machsupport Forum

G-Code, CAD, and CAM => LazyCam (Beta) => Topic started by: docltf on May 17, 2007, 09:38:26 PM

Title: Lcam201 mill
Post by: docltf on May 17, 2007, 09:38:26 PM

thanks art and brian i had a good time today

lcam is really looking good.my first question is what does overhang % control.I cut 3 parts with overhang at 0,30 and 70 no change,or is it
connected to the clamp option.i have not played with that yet.
next question,when i post from lcam to mach3 loads well,when i ask to load the same file from mach3 it will not import the file
and when you check mach3 the file is lost.i attached a screenhunter shot.

bill

Title: Re: Lcam201 mill
Post by: Brian Barker on May 17, 2007, 09:53:28 PM

We will look into that after we are done the rest of the interface stuff... I think we broke it :(

The Overhang is not needed and I think we are going to take it out soon.
Thanks
Brian

Title: Re: Lcam201 mill
Post by: docltf on May 18, 2007, 04:34:40 AM

Mr.Brian

thats cool,if your thinking about scraping that stuff than how about putting a frame around a text import,so you can
move it around a little,it would make lining it up a little easier.I found another little snag in the pocket move.as soon
as i work up the presentation i will post it.I will be looking forward to the upgrades,but at the moment everything is
wonderful, my junk is running good.

bill