Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: mnms on April 03, 2016, 10:45:31 PM

Title: Direction change constant rate problem
Post by: mnms on April 03, 2016, 10:45:31 PM

Hello, I noticed following behavior in Mach3 (explicit in slow speeds e.g. 1 step/sec):
When direction is changed (G01 X1, G01 X0) step rate is not constant - doubles on turnaround.
Can it be disabled?

Title: Re: Direction change constant rate problem
Post by: mnms on April 08, 2016, 05:10:01 AM

Nobody? Other experience to achieve constant slow step rate without accel./decel. (mill profile)?