Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: duffman on January 18, 2016, 02:50:09 PM

Title: slave axis not working
Post by: duffman on January 18, 2016, 02:50:09 PM

hi folks newbie to this forum

im trying to slave my y-a but with no joy. i have tried everything that i have come across on fourms but nothing.
is there anyone who could shed some light on it for me ????

thanks

Title: Re: slave axis not working
Post by: Chipteck on September 01, 2016, 04:46:49 PM

Have you resolved your problem?

Title: Re: slave axis not working
Post by: Ford Prefect on September 02, 2016, 07:44:32 AM

I used the config/slave axis
pull down window

You can also see how to do it in this PDF

http://www.machsupport.com/wp-content/uploads/2013/02/Mach3Mill_Install_Config.pdf

Figure 5-25: Configure Slave Axis Dialog

regards

Title: Re: slave axis not working
Post by: Chipteck on September 02, 2016, 08:27:43 AM

I was going to offer the same document..