Machsupport Forum

Third party software and hardware support forums. => Newfangled Mill Wizard => Topic started by: marktaft on January 18, 2016, 04:39:23 AM

Title: Countersink Option
Post by: marktaft on January 18, 2016, 04:39:23 AM

Hi Ron,

It would be good if the hole wizards also included the ability to do countersink holes.

e.g set the countersink angle , and top diameter , then the system did the rest.

Kind regards

Mark

Title: Re: Countersink Option
Post by: Ron Ginger on January 18, 2016, 08:39:23 AM

Nice idea, I iwll see if I can get that into the Mill Wizard.