Machsupport Forum

Mach Discussion => Mach Screens => Topic started by: leversole on January 16, 2016, 09:30:36 AM

Title: Jogging during pause
Post by: leversole on January 16, 2016, 09:30:36 AM

Created my first screen from scratch and the jog behavior is a little different, I must be missing something...

When I pause a cut, with my new screen, I am not able to jog, using the same profile and switching to the 1024 set, it behaves as expected, that is I can jog, say for a tool change, and when I cycle start again, it goes to the correct place and resumes the cut.

I thought all "settings" were saved in the profile? Don't know what I am missing...probably something simple!

Thanks
Leslie

Title: Re: Jogging during pause
Post by: leversole on January 16, 2016, 09:57:27 AM

Found the answer...for those that don't know...must have the Jog On/Off button on every screen!

Hmmmm....can I put it on the persitant screen for the same effect?

Title: Re: Jogging during pause
Post by: ger21 on January 16, 2016, 10:56:31 AM

Being on the persistent screen, in effect puts it on every screen, so yes.