Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: Jarhead on November 22, 2015, 11:11:25 AM

Title: Spindle Problems
Post by: Jarhead on November 22, 2015, 11:11:25 AM

Mach4, to a PMDX-410, to a G540 to a SuperPID.
The spindle works fine, rpm's are correct.
When I run gcode, the spindle is starting late, meaning the tool is already into the material before it turns on, and it doesn't shut off when I hit the stop or reset buttons. It just goes to the lowest rpm and sits there.

Does Artsoft read these or am I wasting my time posting here??
Meaning is this actual support, or just a user base support?

Title: Re: Spindle Problems
Post by: Tweakie.CNC on November 22, 2015, 11:33:39 AM

I don't think you will be wasting your time posting anywhere on this forum.

Tweakie.

Title: Re: Spindle Problems
Post by: bob_at_pmdx on November 22, 2015, 11:38:22 PM

See the PMDX support forums (this question was posted to both forums):

http://www.pmdx.com/PMDX-Forums/index.php?topic=197.0

I'll re-post the final resolution here when we get one.