Machsupport Forum

G-Code, CAD, and CAM => G-Code, CAD, and CAM discussions => Topic started by: makcnc on August 02, 2015, 04:52:45 PM

Title: need help with artcam post
Post by: makcnc on August 02, 2015, 04:52:45 PM

i'm trying  to make artcam writes plasma codes the point is
how can i make the rapid motions to be in multi lines like
m3
g4 p1
g1 x**** y****   for the feed rate motion
 also
m5
g4 p1
g0 z***
for the safe z

Title: Re: need help with artcam post
Post by: Graham Waterworth on August 03, 2015, 04:27:55 AM

This is not the place to be asking that question, you will do much better on the Artcam forum site.