Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: makcnc on June 17, 2015, 09:09:49 AM

Title: to the masters how to build my post proccessor
Post by: makcnc on June 17, 2015, 09:09:49 AM

hi all I'm concerned with building my Owen post processor to fit my needs
so is there any tool to do this or is it a programming language
is there any tutorials or sites to help
please refer is there any free  tool to do that
also  i found a tool named nx post builder do any body knows about it
and is it free and how to download it
thanks a lot

Title: Re: to the masters how to build my post proccessor
Post by: GaryB on June 17, 2015, 10:36:16 AM

Every program's syntax to machine for post processors vary in some form
so it will depend on what program your using, some will supply postp configuration documentation with the program
Gary

Title: Re: to the masters how to build my post proccessor
Post by: makcnc on June 17, 2015, 05:18:46 PM

what about artcam

Title: Re: to the masters how to build my post proccessor
Post by: GaryB on June 18, 2015, 02:19:02 PM

Quote

what about artcam

What's your question about ArtCam, are you asking if a postp config manual is included? then yes
I write the postp's for Mach3/4 which is include within ArtCam, If you're an ArtCam user and you need something specific then it's easier to make a copy of the post and edit in your required changes. Just remember the post written for ArtCam is not interchangeable with other programs
Gary