Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: master_bebe on June 01, 2015, 11:17:43 PM

Title: How to make Mach3 jump up uppn pressing ESC
Post by: master_bebe on June 01, 2015, 11:17:43 PM

sometimes, when a problem is detected while milling, i have to stop the milling.
when pressing the ESC button, the spindle just stops and stays buried inside the material.
is there a way to make it move up (in Z) for 10-20mm automatically after pressing the ESC button ?

Sincerely, Guy.

Title: Re: How to make Mach3 jump up uppn pressing ESC
Post by: BR549 on June 01, 2015, 11:45:21 PM

Set up your safe Z setting to what you want.

(;-) TP

Title: Re: How to make Mach3 jump up uppn pressing ESC
Post by: master_bebe on June 01, 2015, 11:48:48 PM

thanks. i appreciate it.