Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Davek0974 on April 15, 2015, 10:35:17 AM

Title: Zoom without mouse wheel??
Post by: Davek0974 on April 15, 2015, 10:35:17 AM

Is it possible to zoom the path display without a mousewheel?

Yes I know mice are like 50p each but heyho  ;)

Or is it possible to have it auto-zoom to fit the job each time you load code??

Title: Re: Zoom without mouse wheel??
Post by: BR549 on April 15, 2015, 10:53:30 AM

Mach3 will automatically ZOOM TO the ToolPath selection. IF you have selected TABLE then it zooms to TABLE size. IF it is PART it zooms to PART size.

I will check on the zoom without wheel deal.  BUT I don't think you can.

(;-) TP

Title: Re: Zoom without mouse wheel??
Post by: Davek0974 on April 15, 2015, 10:59:05 AM

ooh, where are table and part selected?

:)

Title: Re: Zoom without mouse wheel??
Post by: Overloaded on April 15, 2015, 12:47:07 PM

Quote from: Davek0974 on April 15, 2015, 10:35:17 AM

Is it possible to zoom the path display without a mousewheel?

Sure.
Hold the Shift key and left mouse button.
Then slide the mouse in the Y direction.
 :)

Title: Re: Zoom without mouse wheel??
Post by: Davek0974 on April 15, 2015, 02:28:19 PM

Thanks