Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: SSPW on March 25, 2015, 09:06:23 AM

Title: Configure an output to follow an input?
Post by: SSPW on March 25, 2015, 09:06:23 AM

Is there a way to configure an output to continuously follow the state of an input in Mach3?

Title: Re: Configure an output to follow an input?
Post by: SSPW on March 25, 2015, 09:32:09 AM

Are "brains" the way to do this?

Title: Re: Configure an output to follow an input?
Post by: TPS on March 25, 2015, 02:06:14 PM

Hi

brainsor or macropump are your friends.

Thomas