Machsupport Forum
Third party software and hardware support forums. => Third party software and hardware support forums. => Topic started by: shinobi on April 11, 2007, 05:10:14 PM
-
Hi,
I'm looking for help with CNC controller mentioned above, extacly with this:
http://www.emisgmbh.de/smc800.htm
(only in german, but this is "foreign language" for me too,;) )
I'm trying to use Mach 3 with this controller, but it doesn,t work, and I don't know : is this the matter of incorrect configuration only, or Mach3 isn't compatibile with this hardware?
If anyone have any information about that controller, please - let me know, I need it desperatly - I have a lot of work to do, my hardware doesn't work, and I don't know why! Thank you for any help again.
Best regards,
Mark