Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: coffcar on January 28, 2015, 04:23:50 PM

Title: New Mach3 download and now my table won't run.
Post by: coffcar on January 28, 2015, 04:23:50 PM

I recently replaced my PC and had to download the Mach3 again. I also added the gecko program for the g540. My table will not run. The motors are activated and in the hold state. The X, Y and Z indicators in the Mach3 program run show the hot keys are functional and moving correctly. However still no table moves. Am I missing something in the config?

Title: Re: New Mach3 download and now my table won't run.
Post by: coffcar on January 29, 2015, 12:16:40 PM

Resolved. The Mach 3 driver was missing. Cloned old hard drive and it is back up and running once again.