Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: bycole on January 08, 2015, 12:24:12 AM

Title: freezing issues
Post by: bycole on January 08, 2015, 12:24:12 AM

I have been running mach 3 without issues for years.   Lately, I have had freezing up issues.  After trying all sorts of remedies today I switched to a new PC and downloaded Mach 3 on it.  This setup is not freezing, however with all the same pin settings and hotkeys as the last set up,  my axis seem to be all mixed up.  The hotkeys that should control the z axis, controls the Y and so on?    I did not change anything on the BOB or any plugs.
Any ideas?   Strange issue.



thanks

Title: Re: freezing issues
Post by: Hood on January 08, 2015, 04:00:34 PM

If you still have the old computer just copy the xml for your profile onto the new computer and all of your settings should be back to original.
Hood