Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: ganadero on December 04, 2014, 01:50:06 PM
-
misalignment of Y axiz in plasma cutting table
Postby LEO ยป Thu Dec 04, 2014 2:22 pm
HELLO GUYS
A few months ago finalize my project in a plasma cutting table 5x10 ft, my compressor capacity was very small so I could only make continuous cuts of 3 minutes Now I have a compressor 80 gallon thing is very different there has been a great problem after 7 or 8 minutes of continuous cutting the y axis misalignment around 3/8" I tightened the screws on the gears and racks all is well fixed , I reviewed mach3 settings and everything is the same in the two motors that move the Y axis someone something happened thank you very much for your support
add pics
-
Possibly an axis is binding causing you to lose steps or it may just be you have your axes tuned too fast, try reducing the Velocity in Motor tuning.
Hood
-
HELLO hood;
you are very kind to take time to help
my cnc kit is a bladeruner of candcnc.com the current configuration of the motor is:
X AND Y: STEPS PER INCH 979.42, VELOCITY 500, ACCELERATION 35
Z: STEPS PER INCH 10,000, VELOCITY 100, ACCELERATION 35
can you give me an advice about the changes that you think suitable for this configuration?
-
Each machine will be different and when using steppers it is just a case of trial and error to find the correct velocity and acceleration.
Hood
-
Each machine will be different and when using steppers it is just a case of trial and error to find the correct velocity and acceleration.
Hood
tanks very much HOOD
this week will try to solve that problem, because it is impossible to work with such failure
-
news about my failure friends;
I've noticed that when I do .tap code in the computer workshop, causes me this fault and when performed on my home computer all going great some friends could tell me i know the reason i use SHEETCAM
tanks very much my friends