Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: ramos on December 02, 2014, 03:15:40 AM
-
Hi everyone, I am new on CNC and would appreciate some help here. I have programmed three circular holes (no tool diameter compensation) using incremental mode, to be cut on a piece of 2.5 mm soft material. The two first holes are fine but the third is not - the X axis just don't move to the right point and the last circle is cut at the wrong position. The same program using absolute mode works fine. Pls notice that the distance between circles are not the same. Any thoughts? thanks
g17g40g49g90
f350
g1z50
g0x0y0
g91g91.1
g0x9.35y10
;g1z-53
g2x9.35i-2.15j0
;g1z53
g0x25.05
;g1z-53
g2x25.5i-2.15j0
;g1z53
g0x23.5
;g1z-53
g2x23.5i-2.15j0
...