Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Happy on May 01, 2014, 04:29:16 AM

Title: Mach 3 generates sound "gong" signals into my PC repro
Post by: Happy on May 01, 2014, 04:29:16 AM

If I run some GCode programs, mach3 generates gong souns quite often ( almoust every input Gcode line ... ) .Its same signal as you can hear sometime (why not every time ?) if you press Mach3 Reset button.
I see that this sound is generated every time when Status text line is changed ( my G code input lines are with comments  in brackets and these comments are showed there in status line , however, curious is that not all comments, just some of them ....) .
What is the meaning of this - is it some kind of error message this song, or notification that status is changed ? Should I ignore it ? Is there any way to switch it off in Mach Setup  ?

Title: Re: Mach 3 generates sound "gong" signals into my PC repro
Post by: ZASto on May 01, 2014, 04:36:12 AM

Take out the comments from your G Code :)