Machsupport Forum

Third party software and hardware support forums. => SmoothStepper USB => Topic started by: Richpress on February 05, 2014, 08:30:37 PM

Title: Smoothstepper and G50/G51
Post by: Richpress on February 05, 2014, 08:30:37 PM

Hello all,

Will the smoothstepper support G50 and G51 for axis scaling with Mach3?

Thanks,
Rich

Title: Re: Smoothstepper and G50/G51
Post by: Hood on February 06, 2014, 01:29:13 PM

Yes, I used to use that all the time when I had two turrets on my lathe.
Hood

Title: Re: Smoothstepper and G50/G51
Post by: Richpress on February 06, 2014, 02:43:22 PM

Hood,

That's GREAT!   It means I can do what is needed with very low cash investment.

Thank you for the relpy.

Rich