Machsupport Forum

Mach Discussion => Mach Screens => Screen designer tips and tutorials => Topic started by: Quin on January 08, 2014, 09:29:55 PM

Title: screen problem after upgrading from V1.84 to V3.043
Post by: Quin on January 08, 2014, 09:29:55 PM

I have been using v1.84 with success but wanted to up grade to V3.043 to take advantage of amending the initialization string.  With V1.84 my screen was fine at a 1024 x 768 resolution.  After I installed V3.043, my screen set would only fill about 80% of the monitor at a resolution of 800 x 600.  What am I over looking?

Quin

Title: Re: screen problem after upgrading from V1.84 to V3.043
Post by: Chaoticone on January 08, 2014, 09:53:30 PM

Did you enable High res screens and auto screen enlarge in General config.? You will have to close mach and reopen for changes to those 2 to take effect............. or at least reload the screen.

Brett