Machsupport Forum

G-Code, CAD, and CAM => G-Code, CAD, and CAM discussions => Topic started by: Machguyver on December 30, 2013, 08:43:44 PM

Title: Arc Trouble?
Post by: Machguyver on December 30, 2013, 08:43:44 PM

Hello all,

Please help me figure out the problem with my G-code. Let me start by first saying that I know very little about G-code at this point - but I am trying! When running the attached code in Mach III, the following error appears at line 19
"Radius to end of arc differs from radius to start" or something. I don't know where to even begin to troubleshoot this problem - all I know is I am dead in the water :'(

Thanks!

Title: Re: Arc Trouble?
Post by: ger21 on December 30, 2013, 09:06:47 PM

Try going into general config and changing the IJ mode.