Machsupport Forum

Mach Discussion => FAQs => Topic started by: Goldy999 on December 23, 2013, 10:15:33 AM

Title: Mirror milling
Post by: Goldy999 on December 23, 2013, 10:15:33 AM

I have mange to start cnc from China. But it mills teks wrong way. I am not DaVinci, so I would like to repair this. Does somebody knows whath to do.


Please help

Title: Re: Mirror milling
Post by: Tweakie.CNC on December 23, 2013, 11:05:12 AM

In Config / Ports & Pins / Motor Outputs change the 'Dir Low Active' state for the axis that is machining backwards

Tweakie.

Title: Re: Mirror milling
Post by: Goldy999 on December 23, 2013, 12:57:28 PM

Thank you. the first letter word the mill make ok other again in mirror state.

Title: Re: Mirror milling
Post by: Goldy999 on December 23, 2013, 01:35:20 PM

It works Eureka. Thank you veary much once again.

Do you mybee know how to kontrol spindle in PWM mode. if I have on PWM mode it runs on full speed. komand M5 doesentz help.

You aree the men!!!!
Thanks once again on help.

Best regards,

Gregor

Title: Re: Mirror milling
Post by: Tweakie.CNC on December 24, 2013, 02:11:18 AM

Quote

Do you mybee know how to kontrol spindle in PWM mode. if I have on PWM mode it runs on full speed. komand M5 doesentz help.

Hi Gregor,

If you return to the main page and enter    pwm spindle control    in the search box it will throw up lots of information on how it has been done.

Tweakie.