Machsupport Forum

Mach Discussion => Mach Screens => Topic started by: wade16 on December 05, 2013, 04:09:15 PM

Title: How To Display Mill Table Travel Boundries In The Cutter Path Screen
Post by: wade16 on December 05, 2013, 04:09:15 PM

I would like to know How To Display Mill Table X and Y Travel Boundries In The Cutter Path Screen. That way, I could see if my cutter paths would violate these boundries before I ran the program.

Title: Re: How To Display Mill Table Travel Boundries In The Cutter Path Screen
Post by: budman68 on December 06, 2013, 07:06:16 PM

Hi Wayne,

If you have your table setup correctly, you should see the boundaries of the table when you toggle the button circled in lime green in the picture below.

You may have to hit "regen" after you toggle the button for it to show properly.

Dave

Title: Re: How To Display Mill Table Travel Boundries In The Cutter Path Screen
Post by: wade16 on December 06, 2013, 10:27:55 PM

That worked like a champ. Thank you for your help.

Title: Re: How To Display Mill Table Travel Boundries In The Cutter Path Screen
Post by: budman68 on December 07, 2013, 07:19:52 AM

 :)