Machsupport Forum

Third party software and hardware support forums. => Sieg Machines => Topic started by: wade16 on December 04, 2013, 12:39:45 AM

Title: x3 Mill Homing Switch Install Question
Post by: wade16 on December 04, 2013, 12:39:45 AM

I have optical sensor homing switches on my X3 machine. My question is if I wanted to replace them with plunger limit switches, can I use the same wires that power the optical switch to power the plunger switch? Do I just transfer the wires to the connectors on the plunger switch to make it work? The reason I want to change switches is to obtain more X Y and Z travel without having to take the table apart to reposition the optical sensors.

Title: Re: x3 Mill Homing Switch Install Question
Post by: cnc4pete on May 30, 2014, 08:00:46 AM

Did you get an answer?
If not I can help.
How much more travel do you need? what is total travel?