Machsupport Forum

Third party software and hardware support forums. => PoKeys => Topic started by: rustamd on November 20, 2013, 01:17:53 AM

Title: Not able to get PoKeys56U to work with Gecko G320X
Post by: rustamd on November 20, 2013, 01:17:53 AM

I have been trying to use pokeys56U to output step/dir to my gecko drives to control servo, following the instruction I still dont get anywhere, has anyone had luck doing this, and if so, any pointers?

Using Pokeys software 3.0.65 with Pulse engine enabled.

Thanks,
Russ

Title: Re: Not able to get PoKeys56U to work with Gecko G320X
Post by: NeoTO on November 20, 2013, 02:12:50 AM

Do you get any movement in the DROs and PoKeys pulse engine positions?

Please install the latest version of PoKeys firmware and the new Mach3 plugin - it features a status screen that should show you the status of the Pulse engine.

Regards,
Matevž