Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Bodini on November 12, 2013, 08:55:59 AM
-
Mach 3.043.066
When M6 is called in gcode, the Line # goes to 0. Turns out this is caused by using "GotoSafeZ ()" in M6start.m1s.
Is it just "just one of those things" or what?
-
066 is full of problems.
Hood
-
I agree, Hood, and it shows more and more everyday I try and use additional features. Do you have a recommendation for what version would be good to roll back to (using this on a gantry router)? I wish I could remember what I was using before I updated on this machine. I only just updated another machine from 2.63. That version was good for a long time!
-
I use 057 on the lathes, not sure on the mills but think its the same.
Hood
-
I had picked 058 because most of the changelog after that was lathe stuff. But I will take a copy of 057 too just in case. (total PITA not having non-phone internet in the shop). Thx.