Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: PAbernethy on November 04, 2013, 06:41:18 PM

Title: Newbie Question
Post by: PAbernethy on November 04, 2013, 06:41:18 PM

Is there a way to jog Z while cutting a file ?

Title: Re: Newbie Question
Post by: Hood on November 04, 2013, 06:56:17 PM

Not really although you may be able to set it up if you use plasma and use the THC function. You should then be able to jog the Z within the values you have set.
Hood

Title: Re: Newbie Question
Post by: PAbernethy on November 04, 2013, 07:40:31 PM

Thanks Hood. That's too bad, would be a handy feature for what I do.

Title: Re: Newbie Question
Post by: Hood on November 05, 2013, 03:01:38 AM

What I mean is you may be able to use a plasma profile.
Hood

Title: Re: Newbie Question
Post by: BR549 on November 06, 2013, 12:40:50 AM

The Thc up/down move is really an uncontrolled move not a precision jog move.

(;-) TP