Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: artkraft on September 28, 2013, 01:59:59 PM

Title: ports and pins
Post by: artkraft on September 28, 2013, 01:59:59 PM

I'm trying to use the CW spindle relay as dry contact for my spindle enable. output #6 port 2, pin14. Contacts don't close when spindle FWD is pressed. Output #6 changes state. Is there some setting I am missing or is this not possible. I would also like to use CCW like R2-R9

Title: Re: ports and pins
Post by: artkraft on September 28, 2013, 02:33:42 PM

forgot to say that I am using I06 breakout board