Machsupport Forum
Third party software and hardware support forums. => Newfangled Mill Wizard => Topic started by: TDAY on August 27, 2013, 12:09:57 PM
-
Hello Ron,
Wondering if a simple Hex operation can be added to the NMW? With option of hex size to be taking from points or flats.
Troy
-
yep, thats on the list, and should have been done by now. Actually, it will be a polygon op, any number of sides. It will be a cutout operation, not a full pocket. It will be like circle or rectangle, cut inside, outside or on the line.
Now that we are getting to the end of summer, and boating, I hope to be back to coding
-
Sounds good. This will come in handy for making bolt heads and such.
O ya.... northern winters.... don't miss them at all. ;)
Thanks again,
Troy