Machsupport Forum
Mach Discussion => Mach Screens => Topic started by: checkers on August 08, 2013, 09:14:00 AM
-
Where is a document that describes the Settings screen (f6)?
My setup appears to have position indicators for each drive motor, so the absolute location is shown in the Diagnostic screen.
When I press the 'zero' button in the settings screen for the X axis, I expect to see the DRO get set to 0.000, but is is usually a different value. Lately it has been 0.029 in.
I am not having any success with the 'intuitively obvious'.
So, is there a manual which would explain the Settings screen?
JA