Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Simon0362 on July 05, 2013, 05:08:57 AM

Title: MSM Turn tool tables - need a primer!
Post by: Simon0362 on July 05, 2013, 05:08:57 AM

Hi All,

I am being very dim at the moment trying to setup a set of 5 interchangeable toolholders on my lathe running MSM Turn (not mill-turn) and I seem to be going around in circles.
mach3 is at 067, MSM version is 2.09

Can anyone give me a step by step sequence, ideally using the reference point as the Master tool, otherwise using a defined tool as the Master, all based on the MSM screens?

I thought that something existed but I cannot find any links.

Thanks,

Simon

Title: Re: MSM Turn tool tables - need a primer!
Post by: Hood on July 05, 2013, 07:08:06 AM

Probably best asking on MSM Forum.
Hood

Title: Re: MSM Turn tool tables - need a primer!
Post by: Simon0362 on July 05, 2013, 08:09:11 AM

Hood,
Good point, copy/pasted there as well.
However I thought that I had seen something on the Mach3 forum...

Simon

Title: Re: MSM Turn tool tables - need a primer!
Post by: Hood on July 05, 2013, 08:43:10 AM

There is a MSM section of the Mach forum, its here
http://www.machsupport.com/forum/index.php/board,85.0.html

However Dave usually says best to post on his forum for support.

Hood