Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: m9g on April 26, 2013, 12:56:10 PM

Title: TS3040C-H80 Mach3Mill.xml file setup correctly with swapped X and Y axis
Post by: m9g on April 26, 2013, 12:56:10 PM

Hi

I have finally sorted this machine and have it setup correctly after a lot of available manuals for the same machine with different settings.

I have swapped the default X and Y axis around for what I consider to be a better working area and better suited to most cad/cam software.

After downloading file, if you want to then rename it or leave as it is and put it into C:\Mach3 folder. REMEMBER to open mach3 then choose this file rather than the standard mach3mill.xml file

Here is the XandYswappedMach3Mil.xml file......

Title: Re: TS3040C-H80 Mach3Mill.xml file setup correctly with swapped X and Y axis
Post by: m9g on April 26, 2013, 01:03:36 PM

Admin - I think there is probably a section for this and can I suggest it be sticky please